|
|
|
|
|
|
|
Water Loss Diagnostic Sheet
Diagnostic
If your pool is losing water you will have to ascertain
where the leak is before it can be fixed; i.e. is it the pipes, the main drain or
the liner or shell of your pool?
The following procedure is intended to help you isolate
the leak with a minimum of cost.
Fill pool to halfway up your skimmer opening and mark level
on skimmer face.
Observe change in water level over 24* hours while your pump is running.
Refill the pool to halfway up skimmer face plate opening after 24* hours and shut
pump off for 24* hours to observe water level change again.
* If you have a very slow leak you might have to wait 48 hours between observations.
Results
RESULT A:
If your water loss stops or there is a significant
decrease in water loss when pump is turned off, your leak is probably in the piping
to or from your pool.
RESULT B:
If water loss does not change significantly with
your pump turned off your leak is either in the liner or shell of the pool or in
your main drain.
Solutions
SOLUTION A:
Arrange to have your lines pressure tested by your
Pioneer Family Pools Service Technician.
SOLUTION B:
First arrange for a main drain isolation test of
your pool. If the leak is not found in the main drain a diver will have to be employed
to check you liner for leaks if you have a vinyl pool, or in it's shell if you have
a concrete pool.
|
|
|
|
|
|
|
|
|